1:30 PM
danyrolux
Instructions
1. Download the firmware archive and extract it on desktop.
2. Second, connect MK902 to your computer. Prepare an USB cable (male USB to male USB cable); insert one USB port to computer usb host. Prepare also a thin metal stick; press the recover button like in the image below. Don’t loose the stick, at same time, insert the another USB port to the unit USB slave port. After 3-5 seconds, loose the stick.
3. Install driver using RK Driver Assistant.
4. Burn the image with Rockchip Batch Tool v1.7 using 'Restore' button.
This process will take about 3 minutes, please wait patiently, during recovery/upgrade, don’t remove the USB cable and don’t power off during updating or recovering. First reboot of the unit after recovery/update will take more long time than usual, and even occur some lag issue, it’s normal since internal apk files need to be decompressed and occupy RAM, after 5 minutes, then system will be running well. So don’t worry about that.
4 comentarii:
Rockchip batch tool v1.7 did not recognize the device.
Then I changed config.ini according to this link "http://www.arctablet.com/blog/forum/cube-u30gt2/solution-for-rockbatch-tool-not-recognizing-device-modification-config-ini/"
changing
"SUPPORTLOWUSB=" into
"SUPPORTLOWUSB=TRUE
FULLSPEEDUSB=TRUE"
And suddenly my device was recognized.
What if we have no laptop or desktop? Any hope?
Tomas
You made my day. Without the change in Config.Ini, RBT didn't recognized the device while driver was correctrly loaded :(
Thanks a lot
Dan,
Thanks for all your posts. I suggesth that Tomas infos are emphasized somewhere.
Thanks to both of you.
Guys can I downgrade from 4.4.2 to 4.2.2 using this metod?
Post a Comment